NEC SV8500, Manual

Page: 1528 / 3438

VOL.2-1275
MG-T1(SIP) [SCA-24DTIA]
STEP 4: MBTK (Make Busy of Trunk)
Cancel the make-busy of Virtual Speech Channels.
RT: Route Number of virtual speech channel
TK: Trunk Number of virtual speech channel
MB: 0=Make-busy cancel
STEP 5: AMGIL (Assignment of Media Gateway Information for LDM)
*Make sure to assign in the order ATRK
→
AMGIL.
Assign MG-T1(SIP).
MG-ID:
MAC Address of MG-T1(SIP) (6 byte of HEX data)
* MAC address is labeled on the left front of MG-T1(SIP) (below PWR lamp).
FUNCTION: Setting (to assign MG information)
KIND: MG-T1[SIP]
LINE: 0 (fixed)
CH: 0-1
LENS: Accommodating Location of virtual speech channels.
Click the LENS Set button to open sub window. Enter the first Group of HW to
LENS box, then click TK Check button. Available LENS are listed. Place check
marks to the channels to be registered as virtual speech channels.
*
Make sure to assign LENS by ATRK beforehand.
SETTING OF SERVICE TYPE EXISTS (Signaling Packet):
QoS settings of Virtual Speech Channels
Music on hold exists:
Select either, External hold tone (default)/Internal hold tone 1/Internal hold tone 2.
External music on hold input gain adjustment: 0-15 (default=0)
Country Code:
North America
Law of A/D conversion:
μ
-law is automatically displayed when North America is selected on country code.
STEP 6: AMGVL (Assignment of Media Gateway Voice Control Data for LDM)
*When this command is not assigned, data setting on AIVCL command turns effective.
Assign the voice control data to connect to MG-T1(SIP).
A RT (Storing MG):Route number of virtual speech channel used for MG-T1(SIP).
TYPE:
Select “Route Specified” or “Location ID Specified”.
B RT (MG Storing): Displayed when TYPE=Route Specified is selected.
Used when connecting MG and MG in Tandem. Assign the route number of
virtual speech channel for the destination MG.
B LOC-ID: Displayed when TYPE=Location ID Specified is selected.
Assign the location ID where the destination IP station belongs.
Setting of Jitter Buffer:JB_MIN [0-30 ( × 10 milliseconds)], JB_MAX [0-30 ( × 10 milliseconds)]
Setting Type of Voice Packet Service: IP PRECEDENCE [0-7]/DIFFSERV [00-63]
Setting of Payload: TYPE, SIZE
Note 1
Note 1:
For available payload type/payload size, refer to Peripheral Equipment Description, Volume 1, Chapter 2,
“3.1.1 Bandwidth Required for Voice Traffic.”