NEC Display Solutions of America, Inc.
OL-V652 Installation Guide
10 Point Touch Overlay for the V652
www.necdisplay.com
OL-V652
3
6.0
Integration Procedure
6.1
Place the display face up on a padded surface for overlay integration.
6.1.1
Note that if the unit is already mounted, removing the unit and placing it face up is optional;
integration of the touch screen can also be done while the display is mounted.
6.2
Remove the IR touch screen overlay from packing and verify contents of kit parts.
6.3
Clean inside surface of the glass.
6.3.1
Use a glass cleaner or mild cleaning solution to clean glass.
6.3.2
Spray solution onto clean soft cloth then wipe the surface. Spraying cleaning solution directly onto the
monitor may damage the unit.
6.3.3
Use circular motion to avoid smudges and streaks.
6.3.4
DO NOT USE any chemical solvents such as an Acidic, or Alkali solution.
6.4
With help from a partner, lift the bezel so the top back lip of the touch screen frame clears the monitor.
6.5
Center and slide the top of touch screen bezel over the monitor while holding the bottom of the touch
screen frame approximately six inches out from the monitor.
6.6
Lower the bottom of touch screen overlay until the top of the touch screen bezel hooks to the top rear of
the monitor. Ensure the touch screen bezel has hooked to the monitor prior to releasing the touch
screen bezel.
6.7
Adjust / Pull the bottom of the touch screen bezel over the monitor to its final position. Ensure the USB
cable is not pinched or crushed during this step.
6.8
Install the four (4) bezel retention brackets along the bottom of the touch screen utilizing the 6-32 x 1/4"
undercut Phillips machine screws.
