NEC NP-PA1004UL-W, User Manual

Page: 65 / 236

2. Projecting an Image (Basic Operation)
35
Adjusting the Tilt Foot
1. Turn the left and right tilt foot to adjust.
The tilt foot lengthen and shorten when turned.
Turn one of the tilt foot to adjust the image so
that it is level.
• If the projected image is distorted, see “3-5
Correcting Horizontal and Vertical Keystone
Distortion [CORNERSTONE]” (
→
page 45 )
and “[GEOMETRIC CORRECTION]” (
→
page
113 ).
• The tilt foot can be lengthened by a maxi-
mum of 10 mm/0.4".
• The tilt foot can be used to tilt the projector
by a maximum of 1.4°.
Up Down
Tilt foot
NOTE:
• Do not lengthen the tilt foot any more than 10 mm/0.4". Doing so will make the projector unstable.
• Do not use the tilt foot for any purpose other than adjusting inclination of the projector installation angle.
Handling the tilt foot improperly, such as carrying the projector by grasping the tilt foot or hooking it onto a wall using the tilt
foot, could damage the projector.