NEC NP-02HD, Installation Manual

Page: 58 / 150

58
Setting Up Your Projector
2-3. Selecting the Power Cable for C2 Connection (English)
The power cable for C2 Connection is not included with the projector. Refer to “2-3-1. AC Power Work Specifications” (page 59 )
and provide the necessary power cable.
WARNING
Carefully read the contents described in this section before connection and connect the cables according to the proper proce-
dure. Inappropriate handling may cause fatal, serious or other bodily injuries due to fire or electric shock.
CAUTION
• Before connecting the power cables, check that the main power switch of the projector is turned off. Implement the connec-
tion with AC power shut off.
• Be sure to ground the equipment to ensure safety. Use a power cable that meets the standards and power supply voltage of
the country where you are using the projector (page 59 ), and always connect the equipment to the ground. If the ground is
not connected, it may cause electrical shocks.
• When connecting the power cable plugs to the AC IN and the electrical outlet, securely insert the plugs all the way in. If the
connection between the power cable plug and the electrical outlet is loose, the plug area may generate heat, causing burns
and accidents.
• In order to prevent the power plug from being disconnected from the projector, fix the power cable by using the power cable
stopper supplied with this unit. For how to use the power cable stopper, refer to “Attaching the power cable stopper” (page
59 ).
NOTE
• Install the electric outlet nearby the projector main unit so that the power supply can be cut by unplugging the AC
power cable.
• When plugging in or unplugging the AC power cable, make sure that the main power switch is pushed to the [O]
position. Failure to do so may cause damage to the projector.
• Do not use a three-phase power supply. Doing so may cause malfunction.