NEC NP-02HD, Installation Manual

Page: 59 / 150

59
Setting Up Your Projector
2-3-1. AC Power Work Specifications
AC power supply equipment
Do not use any voltage other than those shown below for the AC power supply connected to the projector.
For C2 connection (when using two different power cables to supply the AC power to the projector and the light source
separately)
- AC100– 240 V single phase, 50/60Hz
(Power supply to the projector)
- AC200– 240 V single phase, 50/60Hz
(Power supply to the light source)
AC power supply cable for the projector
The projector is equipped with an IEC60320-C14 inlet to connect an AC power supply cable. Use an IEC60320-C13 compliant AC
power cable connector and ensure that the connector meets the following current capacity specifications.
Power supply voltage Projector input current Power cable current capacity
AC 100V-240V 4.9 A 10A or higher
Furthermore, use plugs, cables, and connectors that are suitable for the regulations of the country of installation, as shown in the
following table.
NOTE
• For users in North America
Use a power cable no longer than 4.5m/14.76 ft according to National Electrical Code.
• For UK only: In UK, a BS approved power cable with moulded plug has a black (10 Amps) fuse installed for use
with this equipment. If a power cable is not supplied with this equipment, please contact your supplier.
Cable
Plug
Connector
Germany
Plug Cable Connector
CEE 7 H05VV-F 3x1mm 2 IEC60320 C13
USA
Plug Cable Connector
NEMA 6-15P SJT 3 x AWG 16 IEC60320 C13