12
English ...
Installation
mo
lex
MOLEX
E62405SP
R
Connecting the Projector
1.............................................................................................
Power cord (supplied)
2......................................................................................................................
SD Card
3.
..............................................................................................................
HDMI cable
4.
.......................................................................
Computer cable (VGA) (supplied)
5...........................................................................................................
Audio in cable
6.
...............................................................................................
USB cable (supplied)
7.
...............................................................................................
USB memory device
1
3
2
4
5
To the wall outlet
Make sure that the
power plug is fully
inserted into both the
projector AC inlet and
the wall outlet.
Connect to Computer/Notebook
6
7
Note:
When Viewing a DVI Digital Signal
• Use a DVI-to-HDMI cable compliant with DDWG (Digital Display Working Group) DVI (Digital Visual
Interface) revision 1.0 standard. The cable should be within 197”/5 m long.
• Turn off the projector and the PC before connecting the DVI-to-HDMI cable.
• To project a DVI digital signal: Connect the cables, turn the projector on, then select the HDMI input.
Finally, turn on your PC.
Failure to do so may not activate the digital output of the graphics card resulting in no picture being dis
-
played. Should this happen, restart your PC.
• Some graphics cards have both analog RGB (15-pin D-Sub) and DVI (or DFP) outputs. Use of the 15-pin
D-Sub connector may result in no picture being displayed from the digital output of the graphics card.
• Do not disconnect the DVI-to-HDMI cable while the projector is running. If the signal cable
SD CARD
