NEAX2000 IVS
2
General Description
Page xviii
NDA-24293, Issue 2
Regulatory Information On Single-line Analog Telephones
Regulatory Information
Regulatory Information On Single-line Analog Telephones
NEC single-line telephones comply with Part 68 of FCC Rules. On the bottom of the
equipment is a label that states, among other information, the FCC registration
number and ringer equivalence number (REN) for the equipment. If requested, this
information should be provided to the telephone company.
The equipment uses the following USOC jacks: RJ11C.
The equipment should be used only behind a PBX or KTS. The REN is used to
determine the number of devices that may be connected to the telephone line.
Excessive RENs on the telephone line may result in the devices not ringing in
response to an incoming call. In most, but not all, areas, the sum of RENs should not
exceed five (5.0). To be certain of the number of devices that may be connected to the
line as determined by the total RENs, contact the telephone company to determine the
maximum REN for the calling area.
Hearing Aid Compatibility
The D
term
terminals provided for the NEAX2000 IVS
2
are hearing aid compatible.
FCC rules prohibit the use of non-hearing aid compatible telephones.
NEC-type single-line telephone sets used in conjunction with the NEAX2000 IVS
2
are hearing aid compatible. If other than NEC-type single-line telephone sets are to be
used with this system, ensure that these are hearing aid compatible.
Industry Canada CS-03
Certification number: 140 5976 A
Load Number of the equipment: 1.0
NOTICE: The Industry Canada label identifies certified equipment. The certification
means that the equipment meets certain telecommunications network protective
operational and safety requirements. The department does not guarantee the
equipment will operate to the user's satisfaction.
