NEC NEAX 2400 IPX, Programming Manual

Page: 27 / 316

NDA-24305 CHAPTER 3
Page 9
Revision 1.0
BASIC DATA ASSIGNMENT FOR ISDN
2. ISDN TRUNK DATA ASSIGNMENT
STEP 1: ASYD - Assign the following indexes.
SYSl Index 91: Single PLO b7 b6 b5 b4
0 1 0 1
Dual PLOs b7 b6 b5 b4
1 1 1 1
SYSl Index 186: CCIS/ISDN in service b6 b6
1 0 (When b6=1, ISDN service is invalid.)
SYSl Index 187: always 00 (hex)
SYSl Index 220: ISDN is in service For BRI Type of Interface
STEP 2: ARTD - Assign the route data for both Bch and Dch.
Data for Bch/ Data for Dch
The other data should be “0” (default data).
Note 1:
INT (CDN65): 1 N-ISDN2
2 Australia
3 INS 1500
4 ITU (CCITT), ETSI
5 AT&T (#4/#5 ESS)
6 INS 64
7 NT DMS 100 / DMS 250
8 Not used
9 TTC Q931a protocol Tie Line (Japan)
10 Q-SIG. (ETS 300 172)/IS-11572
Note 2: For “SUB ADDRESS - ADDRESSING”, assign “0”. (Refer to “SUB Address - Addressing” in Chapter
6 .)
For “DID ADDRESSING”, refer to “DID Addressing” in Chapter 6 .
2 - ONSG : 2/2 4 - INSG : 2/2 5 - TF : 3/0 6 - TCL : 1/1
7 - L/T : 1/1 8 - RLP : 2/2 10 - SMDR : 1/0 15 - LSG : 12/13
28 - ANS : 1/1 30 - PAD : 4/7 31 - OGRL : 1/0 32 - ICRL : 1/0
34 - GUARD : 1/0 45 - A/D : 1/0 50 - DPLY : 1/0 63 - LYER1 : 0
65 - INT : Note 1 66 - DC : Note 2