NEC NEAX 2400 IPX, Programming Manual

Page: 160 / 316

CHAPTER 5 NDA-24305
Page 142
Revision 1.0
SPEED CALLING-STATION-PRI
S-84 SPEED CALLING-STATION-PRI
1. General Description
This feature allows a station user to dial frequently called ISDN network numbers using fewer digits
(abbreviated call codes) than normally required. With this feature a station user can establish personal
abbreviated codes.
2. Operating Procedure
To operate:
1. Dial the speed calling access code (one or two digits).
2. Dial the abbreviated call code (one or two digits).
3. Call is completed.
3. Programming
STEP 1: ASYD - System Data 2, Index 1, bit 3: Does TOLL RESTRICTION apply to SPEED
CALLING-STATION? 0/1: Yes/No. (If yes, refer to
TOLL RESTRICTION-3/6 DIGIT [T-7]).
STEP 2: ANPD - Reserve a number level for feature access. Assign Connection Indexes, CI = N (Normal).
Assign NND in accordance with a predetermined numbering plan.
STEP 3: ASPA - Two access codes must be assigned for this feature.
For the individual station speed calling number entry, assign the tenant and access code
(ACC). Assign for a Connection Index of Normal. For SRV = SSC, assign SID 14.
For individual station speed calling access, assign the tenant and access code (ACC).
Assign for a Connection Index of Normal. For SRV = SSC, assign SID 21.
STEP 4: ASFC - Assign a Service Feature Class that allows SFI 19 to the stations to receive SPEED
CALLING-STATION.
STEP 5: AISA - Program the tenant, station, type of station, and the number of SPEED CALLING blocks
to be assigned to the Master station.
TN: Tenant
Number
STN: Station Number
MST/SLV: Master/Slave
M-Master Station
S-Slave Station
BLOCK: Number of Blocks
STN: When assigning Slave Station, assign the Master Station number.
STEP 6: AKYD - KYI = 1 FKY = 26 (SPEED CALLING-STATION)
STEP 7: AISD - This command is used to assign, delete and display the destination number of Individual
Speed Calling.