45
4. Using Menus
When not displaying menus, the following screen is normally displayed.
When in standby
When the projector is in a standby state (the projector power switch and light power switch in on), the following is displayed.
When power is turned on
When the power is turned on, the following is displayed.
←
Displays the value of the light source output setting (%).
←
Displays the hours of light source use. (For NC3541L: light source 1 is on the left, and
light source 2 is on the right.)
←
Displays the selected title.
←
Displays the selected video input port.
When the power is turned off
When you press the POWER button on the control panel of the projector for 3 or more seconds, the projector starts cooling. When
cooling finishes, the projector enters the standby mode. The amount of time remaining for cooling is displayed as shown below
during cooling.
When a button is pressed while the key lock function is on
If a button on the control panel is pressed while the key lock function is on, the following is displayed and the button will not
function.
