NEC N8190-173, User Manual

Page: 39 / 52

- 37 -
(1) PCI Express connector
Connector to be inserted into the PCI slot of the computer.

This product’s PCI Express connector type is x8.
(2) Bracket
Bracket to fix this product to the extended slot of Computer.

When fixing this product to a PCI slot optimized for the low profile type, replace the
bracket with the attached low profile one.
(3) SFP+ Module
Module to transmit and receive Fibre Channel signals. Need to remove temporarily when exchange a
bracket or install this product into computer.

Don’t insert the SFP+ module of this product to the other Fibre Channel device.
(4) LED (Port1/Port2)
The three Green LEDs for each port give a visual indication of the operating state.
LED1 LED2 LED3 State
Off Off Off Power Off
On On On Power On (Before POST)
Flashing Flashing Flashing Power On (After POST) or Link Down
Flashing in
sequence
Flashing in
sequence
Flashing in
sequence
Firmware Fault
On or Flashing Off Off 32Gbps Link Up and Active
Off On or Flashing Off 16Gbps Link up and Active
Off Off On or Flashing 8Gbps Link up and Active (not support)
Flashing Off Flashing Beaconing

If the product fails at POST, please check the following items.
- Is the product installed in the computer correctly?
- Are all Fibre Channel cables and power cords connected correctly?
(5) Fibre Channel Connector
Connector (LC Connector) used to connect this product to a Fibre Channel device.
Do not remove dust cover when not connected to Fibre Channel device.
(6)WWPN
The WWPNs of each port are displayed by this label.
Tips
Tips
Notice
Notice
LED3
LED2
LED1