86 Built-in AIT
Important
• When the BUSY LED is lit or blinking, do not turn off the basic processing unit. This may cause
a malfunction or damage data.
• To avoid malfunction, do not transport this unit with the data cartridge installed.
LED indication
Three LED on the Built-In AIT’s front side signal the status of the drive and the AIT data
cartridge.
LED name
Indication status
Description
BUSY LED
OFF
–
ON
Transmitting or receiving the data now
Blink
The data is normally read/written from/to the
data cartridge set in the Built-In AIT.
TAPE LED
OFF
The data cartridge is not set.
ON
The data cartridge is set.
Blink (at a given interval)
The data cartridge is being set or ejected.
The data cartridge set in the Built-In AIT is
deteriorated.
STATUS LED OFF
The data cartridge set in the Built-In AIT is
ready to write data.
ON
The data cartridge set in the Built-In AIT is
not enabled to write data (write-protected).
The Built-In AIT head needs cleaning.
Blink (at a given interval)
During the head cleaning, the cleaning
cartridge tape comes to the end.
The drive is broken.
Reading/writing data
To read/write the data from/to the AIT data cartridge, see the instruction manual provided with the
backup application.
Blink (repeating a long ON
and a short OFF)
Blink (repeating a short ON
(once or twice) and a long OFF)
Blink (repeating a long ON
and a short OFF)