NEC N8104-178, Startup Manual

Page: 42 / 47

E-17
4.2. Unable to Connect the Network
Check the cable
□
Make sure the cable latch has locked
Check the latch of the cable.
If it is not locked, Re-connect the cable.
If the latch is broken, replace the cable.
□
Make sure the cable has not bent
Check the cable routing.
If the cable has bent tightly or has any damage, replace the cable.
□
Make sure the cable has compliance with the standards
Check whether it conforms to the cable specification which can connect this product.
If it is not so, Replace to a proper cable.
S
ee also “6.2.
Network Cables
”(page E-21)
□
Make sure a tip of the cable is not dusty or not broken.
Check a tip of the cable.
If it has broken, replace the cable.
If it is dirty or any dust sticks, Remove the dust or clean a cable of the cable.
Check the link partner (switch, hub, etc.)
□
Check a setting or configuration on the link partner.
Make sure the link partner setting is correct.
If the setting is mis-configured, correct the setting.
If the partner’s port is disabled, enable it.
If the problem persists even after you checked the above items, something may be wrong with
this adapter.
Please contact to reseller, sales agents or service representative.
EU Contact:
NEC Nederland B.V.
Olympia 4, 1213 NT Hilversum, The Netherlands