NEC MultiSync LCD2170NX, User Manual

Page: 11 / 122

English
English-3
Quick Start
To attach the MultiSync LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your
system ( Figure A.1 ). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your
system ( Figure A.2 ). Tighten all screws.
For the MAC: Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to
the Macintosh cable adapter ( Figure B.1 ). Tighten all screws.
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position ( Figure C.1 ).
4. Connect all cables to the appropriate connectors ( Figure C.1 ).
NOTE: If connecting both DVI and D-sub cable, the DVI cable must be connected along side the rib on the power cord side
(
Figure C.1 ).
5. For successful cable management, place the cables in this order into the cable management: Power cord and DVI cable
( Figure C.2 ).
6. Place DVI cable and power cord into the specific hooks indicated in Figure C.2 .
7. Place the D-Sub and the USB cable into the specific hooks indicated in Figure C.2 .
Figure A.1 Figure B.1
Macintosh
Cable Adapter
(not included)
Figure A.2
DVI signal cable
Highest
Stand
Position
30˚ Tilt
D-SUB Cable
Power Cord
Figure C.1 Figure C.2
USB Cable
DVI Cable
Power Cord
DC-OUT
NEC optional product attachment.
Do not use this connector unless specified.
USB
Input1 (DVI)
Input2 (D-Sub)
DVI Cable
01_English 19/12/06, 3:07 PM 3