Quick Start
Figure A.1
3
To attach the MultiSync
®
FE
700
+
™
monitor to your system, follow
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system
(Figure A.1).
Tighten all screws.
For the Mac: Connect the MultiSync FE
700
+ Macintosh cable adapter (not
included) to the monitor connector on the Macintosh
(Figure B.1).
Attach the
15-pin mini D-SUB end of the captive signal cable to the MultiSync FE
700
+
Macintosh cable adapter on the computer
(Figure B.1).
Tighten all screws.
NOTE: To obtain the MultiSync FE
700
+ Macintosh cable adapter, call
NEC-Mitsubishi Electronics Display of America, Inc. at (800) 820-1230.
4. For download information on the Windows
®
95/98/2000 INF file for your
MultiSync monitor, refer to the
References
section of this User’s Manual.
5. Connect one end of the power cord to the MultiSync FE
700
+ monitor and the
other end to the power outlet
(Figure C.1).
6. Turn on the monitor
(Figure D.1)
and the computer.
NOTE: If you have any problems, please refer to the
Troubleshooting
section of
this User’s Manual.
.wpc
11/22/00, 2:16 PM
5