English−16
Setup
For box contents, please refer to the printed sheet provided in the box.
The accessories included depends on the location where the monitor was shipped.
To attach the base to the LCD monitor stand:
1. Place the monitor face down on a non-abrasive surface
(
Figure 1).
2. Please rotate the stand 90 degrees as shown in
Figure 1.
CAUTION:
Please refer to
3. Attach the base to the stand, then tighten the screw at the base’s
bottom (
Figure 2).
NOTE:
Reverse this procedure if you need to re-pack the
monitor.
To connect the LCD monitor to your system, follow these instructions:
NOTE:
“Important Information” on page 3
before installation.
1. Turn off the power to your computer.
2. Place your hands on each side of the monitor to tilt the panel to a maximum tilt angle and lift up to the highest position
(
Figure 3).
Maximum Tilt
Figure 3
Figure 2
Screw
Figure 1
90°
