English-6
Contents
Your new NEC LCD monitor box* should contain the following:
Setup Manual
Power Cord*
1
Mini D-SUB 15 pin to
Mini D-SUB 15 pin*
4
Base Stand
LCD monitor
(Base Stand not connected)
Setup
Manual
DVI-D to DVI-D
cable*
4
Audio Cable*
2,
*
4
DisplayPort cable*
3
•
LCD monitor with tilt base
• Power
Cord*
1
•
Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-SUB male)*
4
•
Video Signal Cable (DVI-D to DVI-D cable)*
4
•
Video Signal Cable (DisplayPort cable)*
3
• Setup
Manual
• Base
Stand
• Audio
cable*
2,
*
4
*
Remember to save your original box and packing material to transport or ship the monitor.
*
1
Type of power cord included will depend on the where the LCD monitor is to be shipped.
*
2
E243WMi
only.
*
3
For North America version.
*
4
For Europe version.
Quick Start
To attach the Base to the LCD stand:
1. Place monitor face down on a non-abrasive surface (
Figure 1
).
NOTE:
Handle with care when monitor facing down, for avoiding damage to the front control buttons.
2. Please pivot base 90 degrees as shown in
Figure 1
.
NOTE:
Handle with care when pulling the stand.
3. Attach the base stand to LCD monitor and properly lock screw of base stand bottom (
Figure 2
).
NOTE:
Reverse this procedure if you need to re-pack the monitor.
Figure 1
Figure 2
Screw