5
11
Turn off the display.
The system setup has completed.
Go to "Using and configuring your computer after setup is complete" (p.5).
The setup process will not be successfully completed and Windows system files or
the registry may be corrupted.
In this case, either perform Windows recovery or consult your place of purchase.
Make a note of the error message and hold down the power switch for at least
four seconds to perform a forced shutdown.
Please wait for at least five seconds before turning the power switch back on. After
that, please see the above "If you accidentally turn off the power during setup".
If the [Activate Windows] screen is displayed, activate the Windows system via the
Internet or by phone call.
<Activation via Internet>
1
Click [Go to PC settings].
When the computer is connected to the Internet, the Windows system is
activated automatically.
<Activation by phone call>
1
Click [Go to PC settings].
2
Click [Activate by phone].
Follow the on-screen instructions and call the indicated phone number to obtain
the confirmation ID.
Activate the Windows system using the confirmation ID.
As a default setting, the first internal hard disk has only one useable partition
(volume), designated as the C:drive.
However, it is possible to divide drive C: into multiple partitions.
Please refer to the following steps if you would like to change the factory default
settings and reduce the size of the C: drive in order to create a new partition from the
resulting unassigned space.
1
Click [Control Panel].
2
Click [System and Security] and then [Administrative Tools].
3
Double click [Computer Management].
4
On the tree displayed on the left side of the window, click [Storage]
[Disk
Management].
5
Select the volume marked as (C:) and right click it.
6
Click [Shrink Volume].
7
Enter the desired size into the [Enter the amount of space to shrink in MB] box.
The size entered here will become the maximum size of the newly created partition.
8
Click [Shrink].
9
After shrinking is complete, select the unassigned space that has been
reserved, and right click it.
10
Click [New Simple Volume].
11
Click [Next].
12
Enter the desired volume size into the [Simple volume size in MB] box and
click [Next].
13
Confirm that [Assign the following drive letter] is selected and click [Next].
14
Confirm that [Format this volume with the following settings] is selected
and click [Next].
15
Click [Finish].
After Windows setup has completed, Windows Experience Index measurements are
performed once your computer continues to be in an idle state for around 15 minutes.
While these measurements are in progress, the power plan will change to [High
performance]. At this time, you may notice the power to the display cutting out.
If you encounter problems during setup
If you accidentally turn off the power during setup
The computer is unresponsive or shows an error message during setup
Using and configuring your computer after setup is complete
If the Windows license is not authenticated yet (Windows
8
.1)
Creating multiple hard disk partitions
• Do not select [Mark Partition as Active] for the newly created partition.
• It is not possible to shrink the [Recovery Partition].
• It is possible to change the drive letter if necessary.
• Depending on the system environment, there may be some cases where
[Shrink Volume] is not possible.
Disk management usage instructions
[Disk Management] help.