Quick Start
To attach the MultiSync
®
LCD monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. For the PC: Connect the 15-pin mini D-SUB of the appropriate signal cable
to the connector of the display card in your system
(Figure A.1)
. Tighten all screws.
For the Mac: Connect the MultiSync LCD
1525M
™
Macintosh cable adapter to the computer
(Figure B.1)
. Attach the 15-pin mini D-SUB end of the appropriate signal cable to the
MultiSync LCD
1525M
Macintosh cable adapter
(Figure B.1)
. Tighten all screws.
NOTE: To obtain the MultiSync LCD
1525M
Macintosh cable adapter,
call NEC Technologies at (800) 820-1230.
Remove connector cover and cable cover.
3. Connect the 15-pin mini D-SUB of the video signal cable to the appropriate connector on
the back of the monitor. Place the Video Signal Cable under Clip B
(Figure C1)
.
4. Connect the audio cable to “Line-in” on the back of the monitor and the other end to the
“Audio out” terminal of the computer. Place the Audio cable under Clip C
(Figure D.1)
.
Replace connector cover and cable cover.
5. Headphones may be connected to the “Headphones” output on the front of the monitor’s
bezel marked “ ”
(Figure E.1)
. While the headphones are connected, the sound from
the speakers will be disabled. Headphones can be purchased from your local electronics
store.
6. Using the USB cable, connect the B type connector to the USB upstream port on the
back of the monitor and A type connector to the downstream part on the computer
(Figure F.1).
If you are using the cord from the USB device, use one of the downstream
port on the side of the monitor
(Figure G.1).
NOTE: Incorrect cable connections may result in irregular operation, damage
display quality/components of LCD module and/or shorten the module’s life.
7. Connect one end of the power cord to the AC Adapter (#A1240T01) on the back of
the monitor and the other end to the power outlet
(Figure H.1)
.
8. Turn on the monitor
(Figure I.1)
and the computer.
9. To complete the setup of your MultiSync LCD monitor, use the following OSM
™
controls:
• Auto Adjust Contrast
• Auto Adjust
Refer to the
Controls
section of this User’s Manual for a full description of these OSM controls.
NOTE: For download information on the Windows 95/98 INF file for your MultiSync
LCD
1525M
monitor, refer to the
References
section of this User’s Manual.
NOTE: If you have any problems, please refer to the
Troubleshooting
section of
this User’s Manual.
3
78134672.wpc
7/16/99, 2:25 PM
5