G277/577 DECT Handset Quick Reference Guide
5
FCC Warning
：
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference
received, including interference that may cause undesired
operation. Any Changes or modifications not
expressly approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following measures:
—
Reorient or relocate the receiving antenna.
—
Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
—
Consult the dealer or an experienced radio/TV technician for
help.
FCC Exposure to Radio Frequency (RF) Signals
For Handset
This is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limitsfor
exposure to radio frequency (RF) energy set by the
Federal Communications Commission (FCC) of the
U.S.Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF
energy for the general population. The guidelines are
based on the safety standards previously set by both
U.S. and international standards bodies. These standards
include a substantial safety margin designed to
assure the safety of all persons,regardless of age and
health. This device and its antenna must not be colocated
or operating in conjunction with any other antenna or
transmitter. This product has been shown to be
capable of compliance for localized specific absorption rate
(SAR) for uncontrolled environment/general
population exposure limits specified in ANSI/IEEE Std.
C95.1-1992 and
h
ad been tested in accordance with
the measurement procedures specified in FCC/OET
Bulletin 65 Supplement C (2001) and IEEE 1528.
ISEDC Warning:
This device complies with ISEDC licence-exempt RSS
standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'ISEDC
applicables aux appareils radio exempts de
licence.L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
The device has been tested and compliance with SAR
limits, users can obtain Canadian information on RF
exposure and compliance
Le présent appareil est conforme Après examen de ce
matériel aux conformité aux limites DAS et/ou aux
limites d
’
intensité de champ RF, les utilisateurs peuvent
sur l
’
exposition aux radiofréquences et la
conformité and compliance d
’
acquérir
ISEDC Specific Absorption Rate (SAR) information
For Handset
SAR tests are conducted using standard operating
positions accepted by the ISEDC with device transmitting
at its highest certified power level in all tested frequency
bands, although the SAR is determined at the
highest certified power level, the actual SAR level of the
device while operating can be well below the
maximum value. Before a new model device is a available
for sale to the public, it must be tested and
certified to the ISEDC that it does not exceed the exposure
limit established by the ISEDC, tests for each
device are performed in positions and locations as
required by the ISEDC. For body worn operation, this
model device has been tested and meets the ISEDC RF
exposure guidelines when used with an accessory
designated for this product or when used with an
accessory that contains no metal.
ISEDC Radiation Exposure Statement:
For Handset
SAR l’utilisation des règles sma l’emplacement Le matériel
de transmission et fonctionnant dans tous les
essais à la certification, même si la puissance suprême a
décidé le niveau, utilisation spécifique peut être
très en deçà de la valeur de référence maximale.Types de
matériel sont vendus au public un ancien, d’essai
et de certification de l’exposition, limite maximum sma,
chaque document et l’emplacement du matériel
d’essai et conformément au document.Le modèle en
physiq
ue, matériel d’essai et conforme aux directives
d’exposition des radiofréquences sma quand une annexe
désigné pour ce produit lors de leur utilisation ou
des pièces de rechange ne contiennent pas de métal.
