Notices and Restrictions
Express5800/120Rg-2
Notices and Restrictions
This document describes the restrictions on Express5800/120Rg-2.
Please read the list of notices
below carefully to ensure that they are followed.
List of Notices
Notices
Models
1
Note when using Remote Management Card (N8115-01, N8115-02)
When using modem for Express Report Service, use serial port A.
<supplement>
When using serial port B (for example UPS), do the setting as below;
In EXPRESSBUILDER menu, ”System Management Function” ->”System
Management Setting” ->”Configuration” ->”Change”->”Common”
Set “Alert” and “Remote Control (WAN/Direct)” as “Disable”.
(Default setting is “Disable”.)
2
Note for Seamless set up with SCSI HostRAID (On-Board RAID)
Configuration
Installation procedure is as follows
(1)
When SCSI back up device is connected, take off cable connection.
(2)
Start “SCSI Select™ Utility” menu in POST, set the HostRAID function on
both of SCSI A/B as “Enable”, and do the installation.
* Refer to the User’s Guide for how to set the HostRAID function.
(3)
After finishing installation, connect back up device with cable.
(4)
Start “SCSI Select™ Utility” menu in POST, set the HostRAID function on the
channel which is connected to the SCSI back up device as “disable”.
* Refer to the User’s Guide for HostRAID setting.
3
Note when using HostRAID configuration on Windows 2000 Advanced Server
+ SP4 (if procured, installed, and supported by customer)
Memory capacity should be 6GB or less. (6GB is supported.)
120Rg-2
4
Note when using LAN for Management
When using LAN for Management, for example Wake On LAN or the alert
function via LAN using Remote Management Card, use LAN#1 port. LAN#2
port should not be used as LAN for management.
120Rg-2
If you have any questions about this document, please contact your sales representative.
4 Express5800/120Rg-2 System Release Notes