NEC ELECTRA ELITE IPK II, System Hardware Manual, Page: 378 / 642

___________________________________________________________________________________
8 - 26 Installing Electra Elite IPK Multiline Terminals
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
S
ECTION
11 A
DJUSTING THE
H
EIGHT ON A
M
ULTILINE
T
ERMINAL
The base plate on the Multiline Terminal is hinged to allow the height of the terminal
to be raised or lowered.
1. Grasp in the middle of the hollow spaces at the top and pull up until the retaining
tabs click to raise the base plate. Refer to
Figure 8-31 Raising the Height on the
DTH/DTR/ITH Multiline Terminal .
2. After the height is adjusted, pull the line cord though the groove in the bottom of
the Multiline Terminal and adjust it.
3. Push on the adjustment tabs on the side of the stand and push down to lower
the base plate. Refer to
Figure 8-32 Lowering the Base Plate on the Multiline
Terminal .
Figure 8-31 Raising the Height on the DTH/DTR/ITH Multiline Terminal
Figure 8-32 Lowering the Base Plate on the Multiline Terminal