NEC ELECTRA ELITE IPK II, System Hardware Manual, Page: 250 / 642

___________________________________________________________________________________
6 - 108 Installing ETUs (Circuit Cards)
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
7.3.5 Removing the Drive
1. Loosen the four screws that hold the drive in place. Refer to
Figure 6-59 Loosen the Four Screws .
2. After the four screws are loosened, push the drive towards the
back plane connector until it is unplugged from the drive
connector. Refer to
Figure 6-60 Push Drive Toward Backplane .
Figure 6-59 Loosen the Four Screws
Figure 6-60 Push Drive Toward Backplane