NEC ELECTRA ELITE IPK II, System Hardware Manual, Page: 241 / 642

Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 99
___________________________________________________________________________________
___________________________________________________________________________________
7.2.1.1 System Board Components
The components identified in Figure 6-51 EliteMail CTI
System Board are listed and described in Table 6-34
System Board Components .
Table 6-34 System Board Components
Item Description
A Backplane connector
B
Switch SW2
Not used. Keep indicated default settings.
C
Switch SW1
Not used. Keep indicated default settings.
D Port Expansion Board (PEB) cable
E Modem connector
F Hard Drive (HD) LED
G Universal Serial Bus (USB) connector
H Local Area Network (LAN) connector
I Keyboard connector
J Mouse connector
K COM Serial Port connector
L VGA Monitor connector
M
Switch SW3
DIP switch 1 default is Off so the voice messaging
application starts when the board is turned On. Set
this switch On to start OS/2 software only.
DIP switch 2 default is Off for direct serial remote
access connections. Set this switch On for modem
connections.
DIP switches 3 and 4 are not used and should be left
On.
N
The power button cuts the power to the board from
the PC and the hard drive and should not be used.
O
Voice messaging software LED
Green when software is active
Amber when active with possible application problem
Red when inactive or shut down