NEC Dterm DTL-RPT-2, Manual

Page: 24 / 30

2 - 12 Getting to Know Your Repeater
___________________________________________________________________________________
___________________________________________________________________________________
Issue 1.0 D
term
Cordless DECT
Figure 2-10 Correct Repeater Installation illustrates repeaters that have been
correctly installed.
S
ECTION
8 I
NSTALLING THE
R
EPEATER
1. Hold the repeater in its final location, and mark the location of one of the two
wall slots along the top of the repeater.
2. From that mark, measure down approximately 1-1/2 inches (about 38mm), and
mark the screw location.
3. Measure over 2-3/8th inches (about 60mm) and mark the second screw
location.
4. At the screw location, use a 3/16ths drill bit to make a pilot hole approximately
one inch deep.
5. Place the wall anchor into the pilot hole and tap it gently with a hammer until the
anchor is flush with the wall.
Figure 2-10 Correct Repeater Installation
Be sure the wall material can hold the weight of the repeater. Never
install a repeater in damaged or decaying wall material.