E-18
How to Install the Projector
■
Installation Sequence
■
Adjusting the Tilt
The position and tilt angle of the projected image can be adjusted by adjusting the adjustable
feet. Press both the left and right tilt adjustment levers to lift the main unit, and release them
when the desired height is reached. You can fine-adjust the tilt by turning the bottom section
of the adjustable feet. Turning this section counterclockwise raises the main unit, and turning
it clockwise lowers the main unit. Also, you can adjust the tilt angle by turning the adjustable
foot located on the rear left of the main unit.
CAUTION
• Do not tilt the main unit at extreme angles by turning only one side of the adjustable feet. Doing so may cause the
main unit to slip or fall down, resulting in accidents or failures.
• Vent A on the bottom of the main unit takes in air to cool the inside of the projector. As air is taken in by large
suction force, cloth or paper may be sucked in against the vent. If this happens, the temperature inside may build
up, and cause an accident or failure.
• The rubber feet may soil the installation surface depending on where the projector is installed.
Check the
installation site
and image size.
Prepare the screen.
Install the projector.
Install the input
devices.
End
See “Projection Distance and
Projected Image Size” on page E-19.
PC, video source, etc.
Extends
foot.
Retracts
foot.
Retracts
foot.
Extends
foot.
Adjustable feet
Tilt adjust levers
