24
Built-in AIT
Setting the parity function
Set the parity function using the leftmost jumper pin on the rear of the Built-In AIT.
The parity function is “Enabled” when setting “Without jumper plug” (factory-set value). The
parity function is “Disabled” when setting “With jumper plug”.
Important
For better reliability, use with “Enabled (Without jumper plug)”.
Setting the Built-In AIT
- Setting with the DIP switch -
The DIP switch on the bottom of the Built-In AIT enables you to change the following settings.
• Terminator Power (Terminator power supply) (Factory-set to OFF)
• DC Control (1) (Data compression setting) (Factory-set to ON)
• DC Control (2) (Data compression setting) (Factory-set to OFF)
1 2 3 4 5 6 7 8
ON
• Do not change the position of the switches 1 to 6.
Switches 1 to 3: Drive Mode
Switch 4: Fan
Switch 5: Terminator Power
Switch 6: Drive Mode
Switch 7: DC Control (1)
Switch 8: DC Control (2)
PD (Factory-set to “Without jumper plug”)
