Programming
10-03 : PCB Setup
118
◆
Networking
Conditions
(A.) When changing a de
Þ
ned terminal type,
Þ
rst set the type to ‘0’ and then plug the new device in
to have the system automatically de
Þ
ne it or rede
Þ
ne the type manually.
(B.) The system must have a PCB installed in order to view/change the options for that type of
PCB.
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 10-03 (PCB Setup):
1.
Enter the programming mode.
2.
10 03
3.
Enter the number of the item you want to program.
4.
Select a slot number to be programmed by pressing the VOLUME
▲
or VOLUME
▼
keys.
Or, press FLASH once to select the slot number or press FLASH twice to select a port num-
ber. Enter the slot or port number.
5.
Enter data for the item you se HOLD.
6.
Enter data for the next item in the program.
OR
Press MSG once to enter a new item number.
OR
Press MSG until you’ve exited that series’s programming section.
10-02-01 Slot No 1
ESIport01 CH1 1 :TEL |1
back
↑
↑
↑
↑
↓
↓
↓
↓
select
10-02-nn Slot No 1
nnnnn
back
↑
↑
↑
↑
↓
↓
↓
↓
select
Summary of Contents for Aspire L
