27
V
o
ice/Videophone Calls
6
Position the FOMA terminal
During remote monitoring, the image captured
with the front camera is sent to the dialing phone.
Place the receiving FOMA terminal in the
monitoring position, and make sure it is switched
on and open.
If the FOMA terminal is left open, only the voice
is sent and the camera image is not sent. The
substitute image is sent with “
カメラオフ
Camera Off” displayed on the image.
Other ID screen (p.26)
Look-up address
……
Look up an address in Phonebook,
Dialed calls or Received calls, and enter the address.
Delete this, Delete all
……
If all IDs are deleted, the “Set”
setting is set to “OFF”.
Starting/Ending remote monitoring
z
To perform remote monitoring, make a videophone
call with caller ID (phone number) notified from the
FOMA terminal registered as the other ID on the
receiving phone.
1
Make a videophone call to the
receiving phone
After the ringing time set on
the receiving phone has
elapsed, remote monitoring
begins.
The video image from the
receiving phone is displayed
and sound comes from the
speaker on the dialing
phone.
■
To answer a videophone
call on the receiving phone without
accepting remote monitoring
X
Press
r
before the ringing time elapses
To answer with a substitute image, press
d
(Subst.).
2
To end the call, press
y
The call duration is displayed and remote
monitoring ends. You can also end remote
monitoring by pressing
y
on the receiving
phone.
N
z
When positioning the FOMA terminal, set
“Videophone” under “Vibrator” to “OFF” to prevent
the FOMA terminal from moving when calls are
received.
z
If the ringing time set for “Voice Mail Service” and
“Call Forwarding” on the receiver side is shorter
than the ringing time set for remote monitoring,
“Voice Mail Service” and “Call forwarding” take
priority.
Dialing phone
N
z
A call can be received as a remote monitoring call
even when Dial lock or Omakase Lock is set.
z
Remote monitoring is not available when the
following functions are set:
• Public mode (Driving mode)
• Manner mode
• Call rejection/acceptation
*
• Reject unknown
*
*: When “Call acceptation” is set for a phone number
other than the other ID phone number or “Call
rejection” is set for the other ID phone number, or
when “Reject unknown” is set and the other ID
phone number is not stored in the phonebook
z
The specific ring tone is used for remote
monitoring and cannot be changed.
z
The ring tone is played at the volume set in
“Videophone” under “Ring volume” (if set to
“Silent”, “Level 1” or “Step”, the volume will be
“Level 2”).
z
You cannot put a call on hold when a remote
monitoring call arrives. Press
y
to end the call.
z
You cannot switch cameras from the receiver
during remote monitoring.
Please be considerate of the privacy of
individuals around you when taking and
sending photos using camera-equipped
mobile phones. Actions that infringe on the
rights of others, or involve the taking and
sending of pictures that are malicious or
against public standards of morality, etc.
may be punishable by law or subject to
claims for damages.
