Nebula NE-SPARK, User Manual, Page: 5 / 8


Install the device in a secure location that is inaccessible to unauthorized persons.This machine
can only be used byadults.
 Make sure there is no flammable material within a 10ft radius of the device.There can be no
objects blocking the use of the machine.

Be sure that the local power outlet match that or the required voltage for your machine.

Can not join any flammable liquid, such as oil andgas.
 Be sure the lid is well covered before use the machine,or the spark will splash out.
5.2Usage method
：
◆
Place the unit on a flat,dry surface. The machine CAN NOT be sidelong or upside down, please
pay attention to keep upright only. Otherwise the spark will not be vertical and probably make the
machine damaged.
◆
fill the powder reservoir with our powder only then tighten the cap.
◆
Connect with the correct power supply and switch on the power button
◆
Connect the W-9 receiver
◆
You can see “OFF” at display board .then use W-12 transmitter –press
power button
on
transmitter to activate the buttons function ,then press
ON(Pre-heat)button
to have the device start
to preheating ,at that time you can see the display change to different data.
◆
When finished warming up ,it will show “FFF” ,and ready LED(above the display board) will
light on
◆
At that time ,you can use transmitter to have it work .or use DMX to have it work .below some
more description FYI:
OFF :Indicates that the machine is powdered but did not start to warming up
FFF: The green light indicates that the machine is ready to Work.
DMX:Red light flashes to indicate a successful DMX
FAULT:Red light indicate error alarm.
6. DMX CHANNELS:
When using the DMX mode, two channels are occupied.
First channel Function
0 Fountain off
1-255 Fountain on
Second Channel Function
0-20 Pre-heat off
，
And the first channel
is invalid
50-100 Pre-heat on
，
And the first channel
is valid
150-200 Clear Materical
，
And the first
channel is invalid