Nebula 200W Beam Moving Head, User Manual, Page: 3 / 10

2. Interface Instruction
2.1. Main Interface
The 3 top right buttons are used for language switching and screen rotation.
The corresponding interface instruction of the 4 bottom buttons is as below.
2.2. Setting Interface
Option Instruction
Operation
Mode DMX Slave state
：
Receive the DMX signal from controller or the
host one
Auto Master state
：
Auto run, and send DMX signal to slave one
Notice
：
If the lamp is off before, it can’t light the lamp by
itself. If you need the observe the lamp effect, please light
the lamp firs, then enter the auto state.
DMX
address 1~51
2 Press the "OK" button to enter edit state. And it chosen the
hundred position, press the "Up" and "Down" button to
change address code. Press "OK" button once again to
select ten position editing. Click "OK" button twice again to
select the unit editing. Click again exit editing state.
CH mode 16 CH17~20 no function
20 CH17~20 control the speed
（
See the channel table
）
X inversion Off
On
Y inversion Off
On
XY
exchange Off
On
Exchange XY channels(Included fine adjustment)