Neat WALL Famiy, Technical Handbook

Page: 19 / 56

neat
19
NE41 11014-02 v4.1 WALL - Technical Handbook
13. The unit starts blinking red, allowing the setting the action for relay 2.
1 2 3 4 5 6 1 2
Picture 13. Sequence 2.
14. Press any button at the appropriate action blink.
15. If programming is successful LED1 rapidly blinks green for 2 seconds.
At any stage during the manual configuration, if there is an unsuccessful
configuration, the LED1 will blink red rapidly for 2 seconds. If this happens the
manual configuration is cancelled and it is necessary to restart the procedure.
In the event of inactivity during manual configuration (e.g. a transmitter is not
activated after #7 or a port/button is not pressed after #11) the unit waits for 60
seconds and then returns to normal mode. No change is saved and the manual
configuraton must then be restarted.
3.7.2 Remove a transmitter
To remove a transmitter, follow steps 1 trough 7 above. After step 7, remove jumper
J2. The device confirms the deletion by rapidly blink green for 2 seconds.