NDS Dometic LSE 105 BF, Installation And Operating Manual

Page: 18 / 352

EN
4. Grind the bonding surfaces on the solar panel and optionally on the roof duct (accessories) with abrasive fleece
( 2 , fig.

).
5. Clean the bonding surfaces on the solar panel and optionally on the roof duct (
3 , fig.  ).
fig.  on page 2
Mounting the solar panel with front connection
(LSE 105 BF, LSE 160 BF, LSE 195 BF, SFS 60WP, SFS 115WP, SFS 140WP, SFS 155WP)
WARNING! Risk of injury
Use a suitable adhesive, e.g. Sikaflex
®
-554. Do not use silicone.
NOTICE! Damage hazard
Before drilling any holes, ensure that no electrical cables or other parts of the vehicle can be damaged by
drilling, sawing or filing.
1. Apply adhesive to the back of the solar panel.
fig.  on page 3
2. Place the solar panel on the prepared bonding surface on the vehicle.
fig.

on page 3
3.
NOTICE! Damage hazard
Do not press too hard on the surface of the solar panel.
Press the solar panel lightly against the adhesive surface to ensure that the solar panel is firmly seated.
4. Drill a hole into the vehicle surface for the connection cable.
fig.  on page 4
5. Route the connection cable from the junction box through the cable gland (accessories) (
1 , fig.

).
6. Route the connection cable through the roof duct (
2 , fig.

).
7. Route the connection cable through the pre-drilled hole into the vehicle interior (
3
, fig.

).
8. Fasten the cable gland onto the roof duct (
4 , fig.  ).
fig.  on page 4
9. Apply adhesive to the back of the roof duct.
fig.

on page 5
10. Place the roof duct on the prepared bonding surface on the vehicle.
Note Mount the roof duct in the direction of travel of the vehicle to avoid wind and rain loading on
the cable gland.
fig.

on page 5
16