20
MF Speed
Choose between eight manual focus speeds.
Near Limit
You can set the camera to ignore focusing on subjects that are closer than a designated distance. Can be set in a
range from OVER, 1cm, 11cm, 30cm, 80cm, 1.2m, 1.4m, 1.6m, 2.0m, 2.5m, 3.1m, 4.2m, 6m, 10m, 20m.
Adaptive P/T (pan/tilt)
When set to ON, P/T speed are adaptive to the zoom range. For example, the higher zoom ratio you use, the slower
the speed of P/T.
P/T Speed
The P/T Speed can be set from 0 to 5 (from low to high), when controlling using the remote controller.
Preset Speed
Set the preset recall movement speed from 0 to 5.
Pan Dir
Camera horizontal Left and right orientation setting, option: Normal/Invert.
Tilt Dir
Camera tilt up and down orientation setting, option: Normal/Invert.
System Menu
Pelco ID
When using RS485 (PELCO P/D) control, set Camera ID to the controlled address. This value is from 001-255.
IR-Receive (Infrared Signal Reception)
When this is set to OFF, the camera does not receive the signal from the infrared remote controller. Be sure to keep
it set to ON when you use the infrared remote controller. Note that you cannot set IR-RECEIVE to OFF when you
operate the menu using the infrared remote controller. To set it to OFF, use the appropriate VISCA controller.
Display Info
When this item is set to ON, the camera configuration is displayed for approx. 3 seconds on the screen when the
camera is powered on or rebooted.
Preset Memory
This feature allows you to save the image parameters to PRESET memory. Parameters such as picture, white
balance, exposure, focus mode, zoom positions can be saved with the preset.
Factory Reset
Select this item to set camera back to the factory default setting. Press the HOME button to confirm the action. All
user settings for the camera will be deleted.
Reload Preset 1
When set to ON, preset 1 is set to the Home position. The camera goes to the Home position when it is powered on
or reset.
Auto Focus
Set the speed of auto-focusing from Low to Normal.
Video Format
To change the format, select VIDEO FORMAT, press the “
←
” button to choose the video format, then press “
→
”
(Pressing “
→
” button changes value on some product models) or HOME button to confirm. After confirmation,
