Data sheet
.
1
Key Facts
Technical
Distinctive features
•
Nominal torque: up to 100 Nm,
bidirectional
•
Speed: ≤ 10
000 rpm
•
Accuracy: ≤ ±0.5
%
•
Operating temperature: -30 °C to +85 °C
•
Protection class: IP50
•
Output signal options: 0-10V / 4-20 mA /
CAN-Bus / USB
•
Cut-off frequency: 1.000 Hz
•
Made in Germany
•
Short delivery time (< two weeks)
•
Excellent price / performance ratio
•
Integrated electronic (Plug & Play)
•
Completely contactless measuring system
•
Delivery including 5 m cable and calibration
certificate
•
Suitable accessories (bracket, readout unit)
2
Torque ranges
Model line
Series 2300
Nominal torque
bidirectional (+/-)
[Nm]
Limiting torque
unidirectional
[Nm]
Limiting torque
bidirectional (+/-)
[Nm]
RPM
[rpm]
Ø 8 mm
1
1.3
1.3
10000
Ø 9 mm
2.5
3.25
3.25
5
6.5
6.5
10
13
13
20
26
26
Ø 15 mm
50
65
65
100
130
130
Note: In case of overload, the sensor leads to an offset in measurement. In such case, the sensor needs to be
recalibrated at NCTE AG. The sensor should be operated only within the specified nominal torque range.
3
Load characteristics
Series 2300
Measuring range
Axial force [N]
1
Limit transverse force [N]
Limit bending moment
[Nm]
1
500
8
1
2.5 and 5
1000
20
2.5
10 and 20
1000
30
12.5
50 and 100
1000
100
41.7
Any irregular stress (bending moment, transverse or axial force, exceeding the nominal torque) up to the
specified static load limit is only permissible as long as none of the other stresses can occur. Otherwise the
limit values must be reduced. If 30 % of the limit bending moment and 30 % of the limit transverse force are
present in each case, only 40 % of the axial force is permissible, whereby the nominal torque must not be
exceeded.
1
Specified values only apply to direct axial force on the shaft. If the axial force acts on the circlip, only 50 % of the force is permissible.
