10
Document Number
DCV-00470
Date Released
Jul. 2020
Revision Number/Security level
R03 S2
Retrofit G6-300 + InvencoLink Wayne Vista 3V (US) Installation Guide
4 Disassembly Procedure
PRECAUTION:
•
Please ensure all safety procedures are followed per requirement by the customer before
installing the retrofit kit.
•
Remove power to Pump and follow the OSHA Lock-out/Tag-out procedures.
•
This installation will require a panel replacement. The panel will be removed from the door and
replaced with a pre-built panel with the OPT pre-fitted.
Before installation of the equipment can take place, the existing electronic payment assembly
must be removed from the dispenser. This section covers the removal of these components
including:
•
The Wayne Graphic Display Assembly
•
The Printer
•
The Printer Bracket
•
The Water Catch Tray
•
The Q-CAT Board (or the dual CAT board)
•
Various Cable Assemblies
1.
At the main disconnect panel, disconnect all power to the dispenser and the pump servicing the
dispenser. Tag all disconnected breakers to prevent others from reconnecting power.
2.
Identify the Side A of the dispenser.
Note
:
For the purposes of this manual, Side A of the dispenser refers to the side with the
manufacturer’s label/Serial Number Plate.
3.
Identify whether the pump is a “Wide Frame” or “Narrow Frame” version from the pictures below –
some steps below vary depending which version you have:
Use a Wayne Security Key to unscrew the two security bolts at the top left and top right of the
electronics head bezel. (Fig. 4.3)
Failure to turn off the unit during installation of the kit may cause injury or bodily harm from electrical shock.
Ensure that all power to the unit is switched off before opening the door of the unit and during kit installation.
WARNING
