7358-K068 R6L Plus Tri-light/Lane Light with Camera
Assembly
21
Configuring Camera Settings
Before configuring the camera settings, do the following:
A. Obtain the IP address settings of the removed camera. This will be used to set the IP
address of the new Camera. For more information, contact an NCR Representative
or the Retailer's Help Desk.
Note:
For new camera installation, IP Addresses are pre-allocated by the Retailer's
IT Team.
B. Install the Tri–Light/Lane Light with Camera assembly, if necessary. For more
information, refer to
Installing Tri–Light/Lane Light with Camera Assembly
C. Install the HikVision Search Active Devices Protocol (SADP) tool, if necessary. For
more information, refer to
To configure the Camera Settings, follow these steps:
Note:
Ensure that the Camera and the device (DVA, lane, computer or laptop) used for
configuration are connected to the same network.
1. Select the SADP tool icon from desktop to open the application.
The SADP interface appears and displays active devices with corresponding
IP addresses, as shown in the image below.