MADE IN USA
NCM Supplies Inc.
2101 N.W. 79 Ave. Miami, Florida 33122
Phone: 305-640-0461 Fax: 305-639-2684
|
www.ncmsupplies.com
2
Front Panel:
The front panel is shown in Figure.
1-
Power LED
- Lights up when the key is turned on.
2-
RF LED ALARM
-Lights up green when the output RF power is ok or red when out of range.
3-
PD LED ALARM
- Lights up green when the input optical power is ok or red when out of range.
4-
Power On Key
- Turns on/off the power
5-
LCD
- Information Display
6-
U, D, R and F key
- Four key from key-board
Rear Panel:
The Rear Panel is shown in Figure.
1-
RF Output
- 75Ω F-type connector input RF signal
2-
RS-232
- DB9 Serial Monitoring Interface (Bit rate: 9600bps, Data bits: 8, Parity: None, Stop bits: 1)
3-
Optical Input
-Class 3B, SC/APC or FC/APC connector
4-
Power Jack
- Supplies power to the equipment
5-
Fuse
- A 220V 1.5A fuse to protect the equipment against short circuits and power surges
6-
RF Test Point
-75Ω F-type connector -20dB input RF signal test point
7- GND
-Case ground
1
2
4
3
5
6
OPTICS
POWER
OPTICAL RECEIVER
OFF
ON
POWER ON
KEY
RF
PD
MODEL OR-200
D
F
U
R
RX#1 RX#2 RX#3 RX#4
^ OK OFF OK ALM
MONITORING
INTERFACE
RS-232
OPTCAL IN
110-220 Vac/ 50-60 Hz
RF INPUT
RX-1
OPTCAL IN
OPTCAL IN
OPTCAL IN
RF-TP
RF-TP
RF-TP
RF-TP
RX-2
RX-3
RX-4
RF-OUT
RF-OUT
RF-OUT
RF-OUT
-20dB
-20dB
-20dB
-20dB
7
5
4
3
2
1
6
8125 NW 64th Street, Miami, Florida 33166
4 Channels Optical Receiver
NCM-OR-200
