NCE POWER PRO DCC Installation And Reference Manual Download Page 8

 

Warranty

This product is fully factory tested and warranted against manufacturing defects for a period of 1 year.  As the
circumstances under which this product is installed can not be controlled, failure of the product due to installation
problems can not be warranted.   This includes misuse, miswiring, operation under conditions beyond the design
range of the product.  No guarantees are expressed or implied as to the suitability of the product for its intended
use by the purchaser.  No guarantees can be made as to the communications range or performance of this
product in the presence of radio or other electromagnetic interference.  It is possible that interference can cause
undesired operation including loss of control of speed, direction etc.  Damage to purchaser’s equipment due to
loss of control is not warranted or covered by NCE.

For warranty or non-warranty replacement send the decoder (and any payment, if required) to:

NCE Warranty Center
899 Ridge Road
Webster, New York  14580

Silent Running, Powerhouse  Pro, Power Pro, Power Plus, Powerhouse Digital Command Control, ProCab,
Switch-It, Snap It, the ProCab logo  with “The Power of DCC” slogan, and EFX are trademarks of NCE Corporation.
Master Series is service mark of NCE Corpration.   Digitrax is a trademark of Digitrax Inc.

Spare Parts:

Spare parts for your cab or RU01
wireless adapter may be ordered
from the list below.  $4 US will be
added to your order for US priority
mail and packaging.   Check or
credit card will be accepted. 
 

Address all parts orders to

 :

NCE Spare Parts

899 Ridge Road

Webster, NY 14580

11/32" hole

11/64" hole

CAB04/05 drill template

This tab folds under cab bottom

Align template with top edge of cab bottom

This tab folds
along side of
cab

This tab folds
along side of
cab

**Last revised:  21 February 2002

Page 8

RU-4/5

$8.00

Rubber keypad for Cab04/05

$1.50

Cab04/05 battery holder

$2.00

Cab04/05 screws (set of 4)

$7.00

Cab04/05 rear cover w/battery door

$2.00

Pro Cab screws (set of 9)

$8.00

Antenna

$3.00

ProCab battery clip set w/wires

$8.00

Rubber keypad for ProCab

$10.00

Procab top

$10.00

ProCab bottom w/ battery door

Price (US $)

Description

Summary of Contents for POWER PRO DCC









Reviews: