NCE D15SR, Manual

Page: 6 / 8

Description of function mapping CVs:
Function mapping can change which outputs are controlled by a function command from
your handheld cab. It is possible to have one command control several outputs. In the
table below each row corresponds to a function mapping CV and each column indicates
an output number. The
bold number in a column is the factory default. Programming the
CV to the value under an output number will change that output to be controlled by that
function number. In the table below the factory value of CV35 is 4 which means F1 will
control Output #3. If you want F1 tocontrol output 4 program CV35 to 8. If you want F1 to
control both outputs 3 and 4 add the two values for those outputs together (4+8=12) and
program CV35 with 12.
Note in this decoder CV33 and CV34 operate identically. They are not
directional...directionality is provided in the EFX configuration CV for each output.
Factory default function mapping values
1 2 CV40 F6
1 2 CV39 F5
1 2
CV38 F4
1 2 4 8
16
CV37 F3
1 2 4
8
16
CV36 F2
1 2
4
8 16 CV35 F1
1
2
4 8 16 CV34 F0 Rev
1
2 4 8 16 CV33 F0 Fwd
1 2 3 4 5
OUTPUT NUMBER
Recommend dropping resistors if using 1.5 volt bulbs
2 watt 160 160 160 150 150 130 130 120
80ma
1 watt 220 220 200 200 200 180 180 160
60ma
1 watt 270 270 240 240 220 220 200 200
50ma
1 watt 330 330 300 300 300 270 270 240
40ma
½ watt 470 430 430 390 390 360 360 330 30ma
¼ watt 910 910 820 820 750 720 680 680 15ma
Wattage 16 15.5 15 14.5 14 13.5 13 12.5 Bulb Current
Track Voltage
**Last revised: 17 November 2003 Page 6 D15SR
Wh
it
e
w
ir
e
Y
e
llo
w wi
re
Green w
ire
V
iol
et
w
ire
S
o
lder pad