NCD RS-485, Manual, Page: 11 / 11

7E 00 24 10 00 00 00 00 00 00 00 FF FF FF FE 00 00 F2 03 00 00 01 00 55 AA 55 AA 55 AA 55 AA 55 AA 55
AA 55 AA 55 FF B1
RS-485 Serial Settings – Emulator
The following commands are used to control the speed and stop bits of the RS-485 bus.
Get Stop Bits:
7E 00 10 10 00 00 00 00 00 00 00 FF FF FF FE 00 00 F7 0D F0
Response:
7E 00 11 90 00 13 A2 00 41 8C 58 B6 FF FE C2 7C 01 00 00 00 A3
Set Stop Bits:
7E 00 11 10 00 00 00 00 00 00 00 FF FF FF FE 00 00 F7 06 01 F9
Response:
7E 00 1C 90 00 13 A2 00 41 8C 58 B6 FF FE C2 7C 00 00 00 00 00 00 FF 00 00 00 00 00 00 00 00 A5
Get Baud Rate:
7E 00 10 10 00 00 00 00 00 00 00 FF FF FF FE 00 00 F7 0B F2
Response:
7E 00 11 90 00 13 A2 00 41 8C 58 B6 FF FE C2 7C 00 25 80 00 FF
Set Baud Rate:
7E 00 13 10 00 00 00 00 00 00 00 FF FF FF FE 00 00 F7 01 00 25 80 57
Response:
7E 00 1C 90 00 13 A2 00 41 8C 58 B6 FF FE C2 7C 00 00 00 00 00 00 FF 00 00 00 00 00 00 00 00 A5
Command Errors – Emulator
Should there be any errors in issuing commands, the following response will be returned:
7E 00 11 90 00 13 A2 00 41 8C 58 B6 FF FE C2 7D 01 00 00 00 A2
Factory Reset
This should be done only when absolutely necessary. To reset the module, follow these steps in order:
1. Power-down the module.
2. Install the C And BR jumpers.
3. Power-up the module.
4. Module will Reset the USART to 57.6k Baud
5. Module will Reset the RS485 Port to 9600 Baud
6. Power-down the module.
7. Remove the C And BR Jumpers
8. Power-Up the module and use default settings.
Note: If the bus length exceeds more than 5,000 feet, users may experience data corruption. This factory reset
process is true only for the Emulator and Autoencoder Version.