NCD Explora 400 Series, Installing Instructions

Page: 50 / 62

Installing Additional Memory
6-10 Installing Optional Equipment in the Monitor Support Base
Reassembling the Monitor Support Base
To reassemble the base, follow these steps:
1. Swing the back of the top section over the back edge of the bottom section
and align the tabs on the top section with the slots on the bottom section,
as shown in Figure 6-10.
2. Lower the front of the top section until the three tabs slide through the
three slots on the bottom section.
3. Replace the front control panel.
4. Replace the PCMCIA card if appropriate. See “Installing PCMCIA Cards”
on page 6-12.
5. Install the cabling. See Section 3, “Basic Installation,” on page 3-1.
6. After the system is installed, perform the memory test. See “Testing
Memory” on page 6-11.
Figure 6-10 Placing the Top Cover on the Bottom Section
Tab
Slot