36
Maintenance
GEARBOX LUBRICATION
To ensure proper lubrication and operating temperatures it is important that the appropriate
lubricants are used and the correct oil level maintained. This level should be checked daily.
NC recommend Fuchs Titan T04 HD10.
GEARBOX OIL LEVEL CHECKING
Ensure the engine is stopped and the transmission oil is cool. Ensure the oil cooler is full by
running the oil cooler a few seconds prior to checking the oil level. In this condition the oil
level should be between the maximum and minimum marks on the dipstick. Gearbox oil
level should be checked daily, and topped up if necessary. Check the oil level using the
dipstick .
At normal running temperatures the oil on the dipstick will rise above the maximum mark.
Do not overfill the transmission as this may result in oil breakdown due to excessive heat
and aeration from the churning action of the gears. Early breakdown of the oil will result in
heavy sludge deposits that block oil ports and build up on splines and bearings. Overfilling
may cause oil leaks.
TRANSMISSION OIL FILL PROCEDURE
It is extremely important to follow the correct oil fill
procedure to prevent internal damage to the transmission.
•
With the engine stopped fill the transmission with
Fuchs Titan T04 HD10 oil to dipstick maximum mark.
Fill point (A).
•
Start the engine and run slowly for a period not
exceeding five minutes. This allows the oil to fill the
filter, pump, torque converter, oil cooler and hoses.
•
Stop the engine and wait approximately one minute,
recheck the oil level and fill to dipstick maximum
level.
Oil is toxic. If you swallow any oil, do not induce vomiting, seek medical
advice immediately. Used engine oil contains harmful contaminants
which can cause skin cancer. Do not handle used engine oil more than
necessary. Always use barrier cream or wear gloves to prevent skin
contact. Wash skin contaminated with oil in warm soapy water. Do not
use petrol, diesel fuel or paraffin to clean your skin.
A