NOTE:
a. Use an angle greater or equal to 90 degrees when there is an LED chip on the corner while placing the strip in a concave
position. (Angle 90º)
b. Use an angle greater or equal to 60 degrees when there is no LED chip on the corner while placing the strip in a concave
position. (Angle 60º)
c. Use an angle greater or equal to 60 degrees when there is an LED chip on the corner while placing the strip in a convex
position. (Angle 60º) In the convex position the angle should not reach 90 degrees. See above diagram.
NOTE:
If you need to secure the connector to the
surface, please remove the protective tape from the red
adhesive of the connector carefully, place the connector
in the desired location and press to ensure proper
adhesion to the surface.
Installation (continued)
8
There are two installation options to choose from:
□
4A Tape method:
Remove the protective tape from the adhesive back of the LED tape light (B) carefully. Place the LED tape light
(B) onto a clean and dry surface in the desired location, press to ensure proper adhesion to the surface. This method is suitable for
indoor installation and can be used for outdoor installation in conjunction with method 4B.
□
4B Tape method:
Place the LED tape light (B) in the desired location. Use the clips (BB) and screws (AA) to secure the LED tape
light (B) as shown. Clips (BB) should be placed in open areas of the strip. Do not cover the LED chips.
4
Installing the LED tape light
a.
b.
c.
LED Chip
Angle 90º
Correct
lncorrect
lncorrect
Angle 60º
IMPORTANT:
Before removing the 3M paper backing, it is important to test the LED tape light in the space you intend to light.
Once the 3M paper backing is removed and the lighting is fully installed, you cannot reposition or move the LED tape light to
another location. The tape may not stick securely.
B
AA
BB
B
