
W W W. N B F. C O M
PARTS
INSTRUCTIONS
PART
DESCRIPTION
QTY
1
Casters
5
2
5-Star Base
1
3
Telescoping Cover
1
4
Cylinder
1
5
Seat Plate
1
6A
Left Arm
1
6B
Right Arm
1
7
Seat Cushion
1
8
Back Cushion
1
9
Back Support Plate
(Already attached to
the back cushion)
1
10
1
" Screws
2
11
/
8
" Screws
2
13
1½" Screws
8
14
Plastic Caps
4
15
Hexagonal Wrench
1
t Seat Height:
, lean forward and reach under the
he chair to find the handle. Lift the
INSTRUCTIONS
A. Remove all parts from the carton and separate them into part number groups as indicated in the parts list.
B. To begin assembly, place the 5-star base (2) upside down and insert casters (1) into the bottom of base (2).
C.
D. Place the telescoping cover (3) over the the cylinder (4) and rest it on the base (2).
E. Attach the seat plate (5) to the bottom of the seat cushion (7) (with front of seat plate facing the front of the
seat cushion) by using 1 /
8
" screws (10) into the front holes of the seat plate (5) and /
8
" screws (11) into the
rear holes of the seat plate (5) and
tighten the screws
.
F. Align the back cushion (8) with the seat cushion (7) by positioning the back support plate (9) over the seat
plate (5) with 1¼" screws (12).
Do not tighten the screws completely.
G. Attach the arms (6A & 6B) respectively on each side onto the bottom of the seat cushion (7) and the sides
of back cushion (8) by using 1½" screws (13).
Tighten all the screws. Remember to tighten the screws on the
back support plate.
H. Place the plastic caps (14) into the two arm holes on each arm.
I. Place the assembled chair on top of the cylinder (4) and press down until fully engaged.
J. Periodically (every 90 days) make sure that the screws are still fully tightened.
CUSTOMER SERVICE HOTLINE
800-626-6060
ATTENTION:
Make certain to fully tighten all screws
before using chair.
A S S E M B LY I N S T R U C T I O N S
Congratulations on the purchase of your new
Signature Series
chair!
MORGAN HIGH-BACK CHAIR
12
1¼" Screws
4
7
5
7