ASSEMBLY OF WORKSTATION
Two people are recommended for assembly. Approximate assembly time: 20-25 minutes.
The reference numbers used throughout this sheet refer to the illustration on the back cover.
This is to help you to identify the various parts as they are mentioned.
1.
Lay the top (Ref. No. 1) face down on two sawhorses or
a protected flat surface with the predrilled holes facing up.
2.
Place an adjustable leg (Ref. No. 2) on one end of the
top, aligning it with the eight pre-drilled pilot holes.
Attach with eight #14 x
3
/
4
” hex head slotted wood
screws (Ref. No. 8).
1.
Remove the top drawer (A) from the housing (C) by first
pulling it to the full extent that the suspensions allow.
Once the drawer is fully open, lift the drawer off the suspension
member to release the suspension sections. Follow the
same procedure with the bottom drawer (B).
NOTE: The stringer attaches to the
flat area on the outside of each leg.
Use four bolts, nuts, and lockwashers
on each end of the stringer.
2.
Using the housing as a template, mark locations of the
holes for the wood screws onto the underside of the wood
top. (Recommendation is 1/2” offset from front of wood
top.) Next, drill four holes 1/2” to 3/4” deep into the wood
top using a
5
/
32
” drill bit. Once you’re finished, secure the
housing to the top using four #14-3/4” hex head slotted
wood screws.
5.
If you purchased only the basic workstation, your work
is now complete. The remaining instructions show
assembly of the optional accessories.
4.
Attach the stringer (Ref. No. 1) to the rear legs, skipping the
top two holes and using the next four holes from the top
of each leg. (The legs are symmetrical, so front and rear
of the bench will be determined by where youplace the
stringer.) Attach the stringer with four
1
/
4
”-20 x
5
/
8
” bolts,
lockwashers, and nuts (Ref. No’s. 8, 9, 10) on each side.
NBF • (800) 558-1010
3.
Place the other adjustable leg on the opposite end
of the bench top, using the same procedure shown
in step 2.
NOTE: If attaching an optional drawer unit, you may want to leave the
bench in the upside-down position.
OPTIONAL ACCESSORIES
Drawer Unit Assembly
3.
Now turn the table upright and place the drawers
(which were taken out in step 1) into the suspensions
in the housing. Your workstation with drawer is complete.
“L” Shape Leg Assembly
1.
Turn the wood top face down. Using the holes in the
Leg Plates as a template, mark the locations on the
underside of the wood top for the wood screws. Then
using a
5
/
32
” drill bit, drill eight holes into the top, about
1/2” to 3/4” deep on each side. Next, secure each leg to the
top using eight #14-3/4” hex head slotted wood screws per leg.
2.
Turn the table over and line up with the already assembled
workstation to create an “L” shape. Once the tables are
together, drill four holes through the plate under the
assembled workstation and secure with four #14-3/4”
wood screws.
3.
Now your extended “L” shape workstation is finished!
(
A
)
(
B)
(
C
)
For assembly and installation of an Electronic Riser, please refer to the instructions which came with the Riser Kit.
NOTE: After marking where the holes
need to be, move the drawer housing
to the side before drilling.
