NBB HyPro-6, Operating Instructions Manual

Page: 23 / 40

TEACHMODE
NBB CComponents GmbH Otto-Hahn-Str. 3-5 D-75248 Ölbronn-Dürrn Tel.: 07237-999-0 Fax: 07237-999-199
Set all analog channels to 0-position and release the
EMERGENCY STOP
switch.
Wait until a radio connection is present. Press and hold the buttons “ S2 ”, “ S5 ” and
“ S6 ”.
As a confirmation the horn will be activated briefly twice in a row and “TEACHMODE
ON” is shown on the display.
Release the buttons “
S2” , “ S5 ” and “ S6 ”.
To determine the analog function you want to program, the
corresponding joystick
must be deflect completely briefly in the direction of this function and returned back to
0-position
.
If a new analog function or the opposite direction is programmed or you switch
between the minimum and the maximum speed of a channel, the desired analog
function must be selected again.
Press the button “ S9 ”. A tortoise is shown on the display.
The lower threshold value is saved by deflecting the master switch until the desired
minimum speed of the function is reached and pressing the “
S1 ” button.
Press the button “ S8 ”. A rabbit is shown on the display.
The upper threshold value is saved by deflecting the master switch until the desired
maximum speed of the function is reached and pressing the “
S1 ” button.
The opposite direction can be programmed in the same way. See point
3) and 4)
.
Programming several analog channels successively:
Afer saving a value with the button “
S1 ”, the next analog channel can be programmed.
Start again from point
2)
.
To cancel a current programming process, press the button “ S12 ”.
Press the
EMERGENCY STOP
switch. Release the
EMERGENCY STOP
switch after
2 seconds and press the button
“ ON/HORN(S7) ”
to switch on the control.
1) ) Activate
programming
mode
2) Select analog
function
3) Save the
minimum speed
4) Save the
maximum speed
5) Program
opposite direction
6) Programming
of the next analog
function
7) Shut down the
programming
mode
Set all analog channels to 0-position. Release the
EMERGENCY STOP
switch. Wait
until a radio connection is present. Then press and hold the buttons “ S1 ”, “ S5 ” and
“ S6 ”.
The factory settings/ default values are automatically restored. As a confirmation the
horn will be activated briefly four times in a row.
Release the buttons “
S1 ”, “ S5 ” and “ S6 ”.
After that press the
EMERGENCY STOP
switch and release it after 2 seconds, to
switch into the working mode.
8) Restore the
factory settings /
default values