Manual Instructions for Gas Wok Ring Table
NAYATI
AMICUS
15
•
Gas Supply Connection
-
Before installing and connecting Gas Wok Ring Table to gas supply, carefully
control the fixed part of gas system, which conformed to National Building
Regulation.
-
Verify gas pipes sections to guarantee sufficient supply for all gas heated
appliances. Install it in similar condition to avoid excessive pressure drops.
-
The pipes must be made of steel (with junctions made using white cast iron, or
galvanized steel fittings, or autogenously welded joints) or copper pipes (with
mechanical joints and couplings without seals or mastics or brazed joints).
-
Control the gas bottle (if any) placed correctly and protected in dry area.
-
Check whether the gas pipes can easily inspected. If the pipes installed in floor
and wall, make sure that this work done according to professional standard with
reference points that make it possible to find the pipes.
-
Before installing Gas Wok Ring Table, make sure that it is set for the gas and
pressure (see Technical Data Plates). Consult the paragraph “Gas Conversion”.
-
Connect Gas Wok Ring Table to gas supply using solid fittings or flexible steel
pipes with suitable sections related to nominal power and length.
-
Check whether the flexible pipes does not pass or near hot surfaces, put under
stress and traction, contact with sharp edges, or other things that could damage
the pipe.
-
Install quick ON – OFF valve between the gas mains and each single appliance
where easy to reach.
-
After install Gas Wok Ring Table safely, take a pressure test the whole gas circuit
by using leak finder spray or non-corrosive foams.
-
Gas Wok Ring Table is equipped with ISO 7/ 1 screw thread, gas connection of
3/4 inches diameter and suitable adapter for ISO 228/ 1 G screw thread gas
connection are provided together with the appliance according to destined
countries.
20140227
