Connecting Power
www.naxa.com
Page 9
Symptom
There is no power.
Device is unable
to connect to the
speaker.
The device is
connected but
there is no sound.
Possible Cause
The power switch is set to Off.
Battery dead.
Troubleshooting Guide
Solution
Make sure the switch is
set to ON.
Charge the battery.
The speaker is not in pairing
mode.
Bluetooth is disabled.
Power cycle the speaker
Enable Bluetooth mode
on your device.
The AUX connector may be in
use.
Your device may be too far
from the speaker.
Your device is not in playback
mode.
Disconnect the AUX
cable from the device.
Move your device
closer to the speaker.
Ensure your device is
operating correctly.
Start playback.
This guide lists common problems and their solutions.
solutions. Please refer to this guide before requesting
service. If you need further assistance, please contact
Naxa Technical Support @ www.naxa.com/naxa_support/
If you insert a USB drive or MicroSD card while in
Bluetooth
®
Mode, the unit will disconnect from
Bluetooth
®
and begin playback in USB or MicroSD
mode. Press the Mode button to return back to BT.
Your speaker has an integrated rechargeable
battery. Upon initial use, the battery should be
fully charged to ensure optimal performance
and battery life.
Use the included USB charging cable to connect
the speaker to a USB power source to charge the
battery.
1.
2.
Connect the USB charging cable (included)
to a DC 5V charging port of the speaker
and insert the other end into a USB port on
your computer or a similar power source.
Red LED indicator signifies that the unit is
charging. Once the unit is fully charged, the
LED indicator light will turn off.
it takes approximately 3 to 6 hours to charge the
unit fully when connected to a standard USB port.
Do not charge the unit for more than 8 hours to
optimize the lifetime performance of the battery.
