10
NavTool.com | Call: +1-877-628-8665 | Text: +1-646-933-2100
Step 13:
Assemble the navigation headunit in reverse order of steps, staring from step 6 down to step 1.
Step 14:
Connect both 10 pin connectors on the Interface harness and the Vehicle Specific Harness
LONG-RIB together.
Step 15:
Cut off the Red (+12 Volts ACC) and Black (Ground) wires off of the 6-pin plug on the interface
harness.
Step 16:
Connect the Red wire (+12 Volts ACC) to the Vehicle’s factory accessory wire. (Purple wire on the
power plug)
Step 17:
Connect the Black wire (Ground) to the Vehicle’s factory ground. (Black wire on the power plug)
Step 18:
Connect the Orange wire (+12 Volt Reverse Input) to the Vehicle’s factory reverse wire. (Rev. Light)
Step 19:
Connect one wire of the push button to +12 Volt ACC power in the vehicle and the other wire to the
white manual activation wire on the interface harness. (Not required for installations with reverse camera only)
Step 20:
Connect your aftermarket cameras/video inputs to Rear Camera Input/Video Input 1 and Front
Camera Input/Video Input 2 on the interface harness.
Step 21:
Make sure both dip switches on the interface are facing UP in the OFF Position. Plug the interface
harness into the interface.
See Next Page for Quick Connection Diagram >
Installation Instructions
